• 4 Roll Drive 50W Motor provides consistent, strong drive for a variety of wires.
• High & Low Speed Range provides 1 to 10m/min or 8 to 20m/min speed, giving finer control of wire speed - particularly useful at lower voltage settings.
• Arc Start Control allows starting response to be fine tuned to weld conditions.
• Creep Start Mode provides slow wire speed until weld starts - ideal for aluminium starts.
• Purge allows gas line to be purged, without feeding wire.
• Inch allows wire to be fed without wasting gas.
• Latch provides gun switch trigger to start and then again stop, reducing operator fatigue on long welds.
• Post Gas allows gas to continue flowing after weld has finished.
• Pre Gas allows gas to flow before weld starts.
• Burnback controls how far the wire burns back to the tip on completion of the welding operation.
• Spot Time provides short weld times for repetitive spot welds.
|
Single Phase MIG
