- W64 4 Roll Drive Wirefeeder
- 3.6m Euro Gun Cable
- Bernard™ Centerfire™ Tip 0.9mm
- 10m Work Lead
- 10m Interconnecting Leads
- Gas Regulator/Flowmeter
- Drive Rollers: 0.9/1.2mm "V", 0.9/1.2 knurled (gasless, flux cored, metal cored)
This 396 Amp three phase MIG welder is ideal for medium to heavy fabrication, and all general industrial fabrication applications.
Optimal weld characteristics provide high quality results on steel, stainless steel and aluminium, plus the power to comfortably run all popular sizes of solid and flux cored wires. With the capacity to run 1.6mm flux cored wire, the 396 can handle a wide range of applications.
The power source features a built-in thermal protection device that will cut in if the machine is operated beyond its safe thermal operating zone.
Featured on the 4RD wirefeeder - leaves the wire tip extra clean at the end of the weld.
Digital Volt and Amp meters retain last weld information and allow precise set-up.
30 Voltage steps for fine arc control over the whole operating range, from short arc to full spray transfer.
Exclusive split handles with rubber grips, designed to move the machine easily and allow composite work lead and MIG gun to be stored independently.
Suits gas shielded and flux cored wires.
5kg & 15kg.
Every Weldmatic machine is backed by WIA’s industry leading ‘Gold Shield 3 Year Warranty’, covering parts and labour, and supported by an Australia wide service network. You can be guaranteed you’re buying reliability and performance. For details, refer to the Weldmatic warranty statement.
Now with larger, stronger gears and ball bearings to further enhance the reliability and performance of Weldmatic machines.
All Weldmatic machines are supplied with an industrial quality gun and cable, complete with euro connector for easy fitting and removal.
By only operating when needed, the fun uses less power and generates less noise. The result is a reduction in dust build-up inside the machine, meaning less maintenance time and longer component time.
W64 wirefeeder enables custom set-up to suit the job - including arc start, low wire speed, burnback, spot time, trigger latch, inch, purge and pre and post gas.
A new addition to the Weldmatic range is the easy screw spool hub, allowing for quick installation of 5 and 15kg spools.
Weldmatic machines have been engineered to deliver smooth arc performance right across the welding range.
Engineered for reliability, the heavy duty transformer delivers a smooth, consistent weld performance.
Fold down tool tray provides storage for gun contact tips and nozzles.
Dual handles make it easy to move your Weldmatic around the workshop, plus provide handy storage for interconnecting work leads.
Every Weldmatic machine is backed by WIA’s industry leading ‘Gold Shield 3 Year Warranty’, covering parts and labour, and supported by an Australia wide service network. You can be guaranteed you’re buying reliability and performance.
|Primary Voltage||Rated Primary Current||Max. Primary Current||Recommended Generator kVa||Rated Output @ 40C (10min)||Welding Current Range||Wire Size Range (mm)||Shipping Weight|
|380/415 Vac -|
50 Hz 3 Phase
|15 Amps||27 Amps||20 kVA||395 A, 34 V, 30%|
250 A, 26 V, 100%
|19 - 395 Amps||0.8 - 1.6 solid|
0.8 - 1.6 cored